Solution for Needing Replacement Drive Coupler for Lippert Stabilizer Jack for RV

Question

Question:

can i buy a motor drive coupler for my lipper rear stabilizer jacks

asked by: Gary M

0

Expert Reply:

For the Lippert stabilizer jacks like the # LC369774 we do not have replacement motor drive couplers available. If you were in need of one the only solution would be an all new motor like with the part # LC352338.

expert reply by: Jameson C

0

Answer 1

Hey Chris, thanks for reaching out@ Yes, the 5-Leaf Double-Eye Spring for 6,000-lb Trailer Axles #TRU32FR can be installed in either an overslung or underslung configuration. Are your current leaf springs in the overslung configuration?

view full answer...

Answer 2

I believe you are referring to the Lippert Components High-Speed Power Stabilizer Jack part #LC369774 that comes with the white switch part #LC144214. Lippert was not able to provide me a wiring diagram for the white switch but was able to give me…

view full answer...

Answer 3

We have actually heard from Lippert about this type of issue and they recommend replacing the 6 amp fuse with a 30 amp fuse. This should resolve the issues you're describing.

view full answer...

Answer 4

If you take a look at the accompanying photo, you can see the correlations between color and function of the Lippert Components Slide-Out Switch Assembly - Black #LC117460. The black wires are ground, red is power, yellow is extend, and green is…

view full answer...

Answer 5

Yes, you can upgrade your 13.5k BTU AC unit on your camper to a 15k unit like with the Advent Air RV AC Unit part #ACCAR150 like you mentioned.

view full answer...

Answer 6

The plate you are referring to in the RoadActive Suspension Custom Leaf Spring Enhancement Kit - Heavy Duty #RAS3611-CHD will replace the upper overload on your suspension if you have it.

view full answer...

Answer 7

Hey Danny, this is a really great question but B and W states that their fifth wheel to gooseneck adapters like the part #BW83RV actually put less stress on the RV frame than a pin box so the warranty would not be affected. Lippert might take a…

view full answer...

Answer 8

I do have a solution for you to have a working stabilizer again but unfortunately when I spoke with my contact at Lippert he said that the legs on your 198641 unit are not replaceable alone. Instead you will need to replace the whole stabilizer jack…

view full answer...

Answer 9

Hello David, Congratulations on the new camper! Where did you take the Keystone for its first trip to break it in, or are you tackling a few repairs before hitting the road? I just got back from the Valley of Fire near Las Vegas last week, and it was…

view full answer...

Answer 10

Welcome back Rich and thanks for the information! To replace your Sharp Carousel microwave R-820BK-F, I recommend the Greystone Built-In RV Convection Microwave item #GR27FR. It measures 21" wide x 11" tall x 15-3/4" deep.…

view full answer...

Answer 11

Thanks for the information David and welcome back! The Hellwig Rear Anti-Sway Bar item #HE78RR is the correct one for a 2026 Ford E-450 chassis. However, for the front you'll need the Hellwig item #HE26GR. This is a 1-3/8" diameter front…

view full answer...

Answer 12

The direct replacement for your Lippert Model 113407 stabilizer jack is part #LC369774. I confirmed this with my contact at Lippert. It requires an easy bolt-on installation.

view full answer...

Solution for Needing Replacement Drive Coupler for Lippert Stabilizer Jack for RV

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching