Accessing the Third Brake Light Wire on a 2014 Chevy Silverado

Question

Question:

how to locate the 3 brake light wire on a 2014 Chevy silverado .

asked by: Dale

0

Expert Reply:

There are a couple of places you can access a dedicated brake light only circuit on your 2014 Chevy Silverado. First, you can tap into the circuit behind the third brake light on the cab of the truck. You can also get the signal from the CHMSL or stop light fuses. Use the vehicle owners manual and/or power distribution box lid to locate the fuses for the center high mount stop light (CHMSL) or stop light circuit.

Another good resource for the third brake light wire under the truck bed, if present, is a company that sells and installs truck bed camper shells.

expert reply by: Michael H

0

Answer 1

If you are looking for a way to power the trailer brakes you would not run the blue wire of the 7-way to the positive post of your battery. Instead you would run that wire up to the blue wire of a brake controller like the part #90885 that you…

view full answer...

Answer 2

The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…

view full answer...

Answer 3

This does not sound like a problem with the Curt Echo #C51180. I would look at the trailer and the wiring. The first thing I would check is the 7-way connection. Make sure there is no corrosion present and clean as necessary. I would also check the…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 10

Hey Rick, the part #e25ZV was not designed to be used with a trailer towing setup. Especially weight distribution as it adds quite a bit more strain on the setup. If you need more length from a weight distribution setup it's best to go with a…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

The Curt Trailer Hitch Receiver part #C15312 is what I recommend as a replacement for the factory trailer hitch on a 2002 Chevrolet Silverado 2500HD. In regards to the bolt hole spacing, this will be a different for the Curt Trailer Hitch Receiver as…

view full answer...

Accessing the Third Brake Light Wire on a 2014 Chevy Silverado

Product Page this Question was Asked From

Continue Researching