Storage Cover Recommendation for 2022 Sunray Classic 149

Question

Question:

2022 Sunray Classic 149 What is the best cover? Live in CO at 5200 ft elevation. We have sun, snow + strong winds

asked by: Pat

0

Expert Reply:

Since your 2022 Sunray Classic 149 is a little over 16 feet long the storage cover you would want is the Classic Accessories Deluxe PolyPro III part # CA80198 which is the correct size, is shaped to fit your style of trailer, and offers heavy duty protection in the harsher climates you have.

expert reply by: Jameson C

0

Answer 1

We offer two sizes of self-tapping button- (or washer-) head screws. Part #FA1131822 has an unslotted hex head and is 1/4 -14 x 3/4-inch long threads. Part #101131802 is #8 x 1/2-inch long.

view full answer...

Answer 2

Hey Jim, yes the Curt True Course #C94VV and the Autowbrake part #3430001 can be used at the same time. The trick will be running the brake output circuit of your trailer 7-way to the same junction box terminal as what the Autowbrake runs to. This…

view full answer...

Answer 3

I looked up the Sunset Park RV Sun-Lite 16BH and the official length is listed at 16' 6" therefore in order to find the correct cover we'll need to subtract 3' for the tongue and round up which means we're looking at a cover for…

view full answer...

Answer 4

We have just what you need for a water proof cover for your canned ham style vintage camper with the Classic Accessories Deluxe PolyPro III part #CA80198 which was designed for the R-pod style trailers that share the same shape as your trailer and is…

view full answer...

Answer 5

The typical tire should run about 158 degrees (Farenheidt) once you get going down the road, but this can vary greatly depending on the weight of the trailer, how fast you're traveling, and also driving habits. So while 158 is probably…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Sure, I can help with that. I can see why the fitment notes are confusing. For a 2012 Toyota Tundra with the factory tow package and factory 7 way connector, you'll want a brake controller that plugs into the factory brake controller port under…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Storage Cover Recommendation for 2022 Sunray Classic 149

Product Page this Question was Asked From

Continue Researching