Troubleshooting Switches Not Working Properly For Lippert Electric Trailer Jack

Question

Question:

The extend retract switch doesnt work on my Lippert Jack model # 1817941 The light has power and turns on and off. If I remove the top cover for the jack, how could I test the switch to see if it needs to be replaced?

asked by: Steve N

0

Expert Reply:

When it comes to checking your retract/extend functions not working it sounds like you may just need to swap some wiring on the back. I will attach picture of the wire swaps. It sounds funny but per the manfuacturer that does seem to help. If that doesn't work I would recommend purchasing the new replacement head # LC285160.

I attached a review video link below.

expert reply by: Noah E

0

wiring swap
(click to enlarge)

Answer 1

Hello Kevin, Sorry for the delay, I had to reach out to Roadmaster on this one. Great question, I get what you’re saying about not wanting threads in the stack-up. Short answer, yes, the Replacement Car-Side Installation Hardware for Roadmaster Tow…

view full answer...

Answer 2

I checked and found the manual for the Lippert Electric Trailer Jack #LC285318 and there was no mention of anything going in the hole beforehand to tighten them. I added a cut out of the manual for you which shows the parts for this jack, and it does…

view full answer...

Answer 3

Lippert does not offer a replacement inner jack tube for their jack 1817941. When a jack is damaged in this way (which is more common than you want to know) it really is best to replace the entire jack for safety reasons. The outer tube on your jack…

view full answer...

Answer 4

Hi Martyn, For your 2020 Keystone Cougar 27SGS Half Ton with the 3 step MORryde step unit, the correct option you’ll want is the MORryde Safe T Rail Telescoping Handrail part #MR54BR. This model is designed to mount to the flat fiberglass exterior…

view full answer...

Answer 5

Hey John! With four steps the MORryde Safe-T-Rail Telescoping RV Hand Rail #MR54BR is likely the better choice over the short #MR54RV. I went ahead and attached the full dimensions of both below so you can see what you think will fit best on your…

view full answer...

Answer 6

Yes, you can back up when The Equal-i-zer Weight Distribution System w/ 4-Point Sway Control #EQ37120ET is installed.

view full answer...

Answer 7

Dang I'm sorry to hear that. It does sound like the converter/charger section is going bad so I'd replace it. The Progressive Dynamics Replacement Section for AC/DC Power Distribution Panel - 45 Amp #PD4645V you were looking at is actually a…

view full answer...

Troubleshooting Switches Not Working Properly For Lippert Electric Trailer Jack

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching