Replacement Landing Gear For A 2010 Forest River Wildcat 5th Wheel

Updated 06/01/2022 | Published 05/29/2022

Question:

I am looking for the correct part to either just replace the complete leg assembly or the entire landing gear set on my 2010 Wildcat 31BH2B. I have replaced the motor and gear box, and there is a section of travel where the motor will skip after I hand crank it past that section, it will work with the motor again.

asked by: Tim M

Helpful Expert Reply:

If you're able to provide a bit more information about your current landing gear setup on your 2010 Forest River Wildcat, I would be happy to see if we have a rebuild kit or a replacement leg for your landing gear, however without that information, the best I can do is recommend a replacement landing gear system.

The Landing Gear Set w/ Handle # RVLG-8HDL should work great for your Forest River Wildcat! This landing gear has 36-1/2" of total lift, a combined weight capacity of 8,000lbs, and can be powered by a 12VDC motor # LC142178 if desired.

Since I do not know what current landing gear you have, you will need to measure to verify that this will work for you. You will need to measure the underside of the top bracket to the top of the lower bracket as shown in the attached image.

From here you will be able to determine if this landing gear will be a good fit for you.

expert reply by: Bryce D