Length of Wiring Harness Electric Ground Control TT Automatic 5-Point Leveling System

Question

Question:

I’m looking at the electric lippert auto leveling kit 672136. I was curious how long the harness are for the jacks . My camper is a vibe 34bh

asked by: Andrew

0

Expert Reply:

I contacted Lippert to inquire about your question. They stated the rear jack wiring harness on the Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System, # LC672136 is 424".

expert reply by: Michael R

0

Answer 1

The B&W Continuum Weight Distribution System part #BW78FR requires at least 24" of space on the frame directly behind the coupler and along the side a few inches back from there. This works with most trailers but for some it will not and,…

view full answer...

Answer 2

The B&W Continuum Weight Distribution System part #BW28FR is great for varying loads since you can easily adjust the tongue weight setting. That said, I don't recommend this system when going off-road as it hangs down too low and could create…

view full answer...

Answer 3

The B&W Continuum Weight Distribution System #BW28FR currently just comes with the 1 shank and it offers a 3-1/2" drop according to my contact at B&W. Currently they don't offer a shank with a larger drop but it may be something they…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Length of Wiring Harness Electric Ground Control TT Automatic 5-Point Leveling System

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching