Locating Driver's Side Connection For T-One Connector on 2012 Volvo XC70

Question

Question:

I cannot locate the “drivers side” red wire connection. Step 8

asked by: David B

0

Expert Reply:

The connection on the driver's side is located behind the side panel. The red wire in step 8 is referencing the T-One connector with the red wire on the # 118774. The connection on the vehicle has multiple wires with various colors running to it which can be seen in the attached picture.

expert reply by: Robin H

0

Tekonsha 118774 Driver's Side Connection on Volvo XC70.
(click to enlarge)

Answer 1

The best hitch for your 2008 Volvo XC70 is the Draw Tite part #75916 which is mostly hidden and has the best towing capacities. I attached an install video for this for you to check out as well. Then for trailer wiring you'd want the part #118774…

view full answer...

Answer 2

For your 2015 Volvo XC70 I would recommend the Curt #13266 over the Draw-Tite #75916. These trailer hitches have an almost identical design. Although the Draw-Tite has a higher towing capacity, it looks like both of the hitches exceed the towing…

view full answer...

Answer 3

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

view full answer...

Answer 4

The best option for an anti-rattle device for a 2 inch hitch is a clamp-on device, and that's especially true for hitches that have the chain rings under the receiver like your #75950. The clamp will go just under the collar of your receiver,…

view full answer...

Answer 5

Our installers removed the rear cargo liner and routed the wire from one side of the vehicle to the other through the trunk and spare tire area. The panel you have open in your photo should allow access to the back side of your taillights. There may…

view full answer...

Answer 6

There are two different sets of tail lights on a 2013 Volvo XC70, a pair in the quarter panel at chest height and a pair in the lower bumper at knee height. I took a look at all the trailer wiring harnesses for a 2013 Volvo XC70 (Curt T-Connector…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Locating Driver's Side Connection For T-One Connector on 2012 Volvo XC70

Featured Help Information

Miscellaneous Media

Continue Researching