Will the Brakeaway Battery Backfeed into My Tow Vehicles Battery?
Updated 03/08/2022 | Published 03/05/2022
Question:
Hi, I have a small trailer and a Tesla. The 7 pin connector on the Tesla powers lights on the trailer, but the brake appears to be powered by an onboard battery on the trailer itself. My question is, how do I make sure that any battery on board the trailer doesnt back feed into the Tesla battery. How can I isolate the two batteries or at least make sure that power flows only one direction, from the Tesla to the trailer?
asked by: S W
Expert Reply:
I believe you are talking about the brakeaway switch on your trailer such as the Hopkins # 20400. The only occurrence when that battery backfeeds into the Tesla battery is if the pin is pulled in the event of the brakeaway. If that pin is not pulled on the brakeaway switch, there will not be any feeding into your Tesla's battery.
If you are still concerned, you can always install the Roadmaster Hy-Power Diode - (Qty 1) # RM-790 so that it is impossible for the current to backfeed into your battery. To install this, you need to splice into the 12v and splice the side going into the front of the vehicle on the input side and the side going back to the vehicle on the diode's output side.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Roadmaster Single Park Light Diode
- Shop: Roadmaster Hy-Power Diode - (Qty 1)
- Q&A: Combining Brake and Turn Signals on 2001 Jeep Cherokee
- Shop: MORryde X-Factor Crossmember Adapter Kit for Drop Down Applications
- Shop: Vehicle Tow Bar Wiring
- Video: Roadmaster Comfort Ride Leaf Spring Suspension Kit Installation - 2020 Grand Design Momentum 5W Toy
- Video: MORryde X-Factor Crossmember Installation - 2020 Grand Design Momentum 5W Toy Hauler
- Search Results: roadmaster comfort ride
- Search Results: tie plate
- Search Results: diode
- Search Results: morryde xfactor
- Search Results: roadmaster slipper spring
- Shop: U-Bolt Plate for 3-1/2" Diameter, Round Trailer Axles with 1-3/4" or 2" Wide Springs
- Shop: Ribbed U-Bolt Plate - 3" Diameter, Round Trailer Axle - 2" Wide Spring - 9/16" Bolts
- Q&A: Why Do Diodes have Two Input Terminals and Only One Output
- Q&A: Are the Roadmaster Hy-Power Diodes Water Tight
- Video: Checking Out the Roadmaster Hy-Power Diode
- Shop: Spring-Eye Bolt with Locknut for Slipper Springs - 4" Long
- Shop: Spring Keeper Bolt with Locknut for Slipper Springs - 3-1/4" Long
- Q&A: Should Bolt Hole On Leaf Spring Hanger Be Larger Than Shackle Bolt
- Q&A: Recommended Shackle Bolts for Slipper Springs
- Q&A: Dimensions for MORryde X-Factor Crossmember Adapter Kit for Drop Down Applications
- Q&A: Do the Input Terminals of Roadmaster Diode RM-790 Touch Each Other
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Video: An In-Depth Look at the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Shop: Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Search Results: trailer tires and wheels
on Trailer Breakaway Kit
