Availability of 14 Inch Trailer Wheel with 6 on 5-1/2 Inch Bolt Pattern

Question

Question:

Where can I find a wheel with 6 lug holes for a14 wheel? Presently using ST215/75R/14 tires.

asked by: Rudy C

0

Expert Reply:

None of the 14 inch wheels we offer are compatible with a 6 on 5-1/2 inch bolt pattern.

To find a wheel with that bolt pattern, you'll need to go with a 15 inch wheel like the Dexstar Steel Mini Mod Trailer Wheel - 15" x 6" Rim - 6 on 5-1/2 - Black # AM20560.

expert reply by: Mike L

0

Answer 1

As long as your 2006 Toyota Tundra has the factory tow package that included a 7-Way trailer plug at the rear of the vehicle, you will be able to find the brake controller port under the dash, to the left of the steering column. It should be taped to…

view full answer...

Answer 2

We see this every now and then with Toyota and Nissan trucks for some reason. It sounds like your running lamp circuit and the 12-v feed are reversed. The easiest thing to do is just rewire the connector on the truck, so your connector will be…

view full answer...

Answer 3

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Availability of 14 Inch Trailer Wheel with 6 on 5-1/2 Inch Bolt Pattern

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching