Does Appearance Panel Get Reinstalled on 2018 Toyota RAV4 w/ etrailer Trailer Hitch
Published 02/18/2022 >
Products Featured in This Question
Question:
Hi, I am interested in Item # e98864, a hitch for a 2018 RAV4. I watched the install video, which was helpful. I do have one question, at 2:30 in the video, it shows removal of a plastic tray on the drivers side prior to installation. It does not show the tray being reinstalled after the hitch is in. Does the plastic tray get bolted back in or does it need to be cut or modified after the hitch is installed? Thanks.
asked by: Keith R
Expert Reply:
Good question, and the panel you are referring to does get reinstalled on your 2018 Toyota RAV4 when installing the etrailer Trailer Hitch Receiver # e98864.
You will trim a small section of it (as shown in the cut out below), and the same push pins and nut that were holding it in will be used to reinstall the panel. So just be a bit careful with the push pins when prying them out and after trimming the small section you can put it back on after the # e98864 in fully installed.
And in the interest of being thorough I also wanted to mention that if you plan to use the hitch for towing with your 2018 RAV4 and need a wiring harness, the correct fit is the T-One Vehicle Wiring Harness # 118578.
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: yakima sightline
- Shop: Trailer Wiring
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Shop: Trailer Hitch
- Shop: Transmission Cooler
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: SightLine Towers for Yakima Crossbars - Flush Side Rails - Qty 4
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Search Results: hitch anti~rattle
- Search Results: stabilizer
- Q&A: Recommendation for Hidden Trailer Hitch on 2018 Toyota RAV4
- Shop: Lamp Guards
- Shop: Roof Rack
- Shop: etrailer Anti-Rattle Hitch Stabilizer for 2" Hitches - Vinyl Coated Steel
- Shop: Stabilizer Jacks - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 2
- Shop: Brake Controller
- Video: Curt T-Connector Vehicle Wiring Harness Installation - 2018 Toyota RAV4
- Video: Installing the Redarc Tow-Pro Liberty Brake Controller on a 2017 Toyota Highlander
- Video: Installation Guide for the Redarc Tow-Pro Liberty Brake Controller- 2024 Hyundai Palisade
- Search Results: red arc liberty
- Search Results: red arc liberty
- Search Results: redarc
- Video: Mount: Curt Trailer Hitch Receiver on a 2016 Toyota RAV4
- Article: Trailer Wiring Diagrams
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Search Results: trailer hitch
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Video: Clean Up Your Trailer Wiring


