Weight Distribution System for Quick Breakdown and Set up on a 6,000 lbs Trailer
Published 01/24/2022 >
Products Featured in This Question
Question:
I have a 26 ft utility trailer that I want to use to haul my 2 side by sides. the total weight is gonna be right around 6,000 lbs. weight of trailer and cargo from what I have read I should be using a weight distribution set up since the trailer weighs more than my 50 of the weight of my truck 2020 F-150 super crew 4x4. my question is what is going to happen when I arrive at my destination and off load?
asked by: Michael B
Expert Reply:
You are correct that you should be using a weight distrubition system with your 2020 Ford F-150. The Blue Ox SwayPro Weight Distribution w/ Sway Control item # BXW1000 would be a great system to go with your 6,000 lbs trailer. It has a 1,000 lbs tongue weight capacity so it will be just over the high end of your trailer's 900 lbs tongue weight but not too high as to cause a stiff ride. This system has clamp on brackets with chain hangers that are super easy to connect and disconnect. Aside from having fun when you get unloaded at your destination all you would have to do is unhook the chains from the brackets and then disconnect the springs bars from the head. The Blue Ox spring bars easily lock in place and remove with included pins and clips. I have attached a couple of review videos.
Product Page this Question was Asked From
Timbren Rear Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Extra Heavy Duty
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: trailer bearings races seals caps
- Search Results: seals trailer bearings races seals caps
- Search Results: trailer idler hub assembly
- Q&A: Hubs for 1" Straight Spindle With 5 on 4-1/2 Bolt Pattern Using 13" Wheels.
- Q&A: Looking For Replacement Hubs For Older Shorelander Trailer
- Shop: Trailer Idler Hub Assembly for 2K Axles - 13" to 15" Wheels - 5 on 4-1/2 - Pre-Greased
- Shop: CE Smith Trailer Hub Assembly w/ Carrying Case for 2,700-lb Axles - 5 on 4-1/2 - Pre-Greased
- Shop: Spindle Grease Seal Set for L44649 Inner Bearing and 1.980 Bearing Buddy
- Shop: Complete Bearing Kit with L44649 Inner/Outer Bearings and 10-9 Grease Seal Fits 1.063" Spindles
- Shop: CE Smith Trailer Idler Hub Assembly w/ Case for 2.7K Axles - 5 on 4-1/2 - Galvanized - Pre-Greased
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: How to Identify Replacement Hub for 1992 Four Winns Liberator 221
- Shop: Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2 - Galvanized
- Shop: Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 5 on 4-1/2 - Pre-Greased
- Shop: Suspension Enhancement
- Q&A: Will Timbrens Work With Weight Distribution Hitch on 2019 Ford F-150
- Q&A: Recommended Rear Suspension Enhancement System for Occasional Towing with 2020 Ford F-150
- Q&A: What Are the Differences Between the Timbren Suspension Enhancement Systems on a 2022 Ford F-150 4wd



