Can a Bolt-On Swivel Jack be Mounted to the Same Bracket as a Weld-On Trailer Jack

Question

Question:

I have a broken Fulton Bolt-Thru Swivel Marine Jack - Weld On and was wondering if the Fulton Bolt-Thru Swivel Marine Jack with Dual Wheels - Sidewind - 12inch Lift - 1,500 lbs can be mounted on the existing weld-on plate?

asked by: Jim W

0

Expert Reply:

You would need to replace the weld-on jack with another weld-on jack of the same type. The bolt on jacks have a different mounting bracket than the weld-on ones. You could use # FXP15W and you may also need bracket # P9012-00 if the old one turns out to not be compatible.

expert reply by: Michael H

0

Answer 1

If you wanted to use the Fulton #FXPD15L jack in place of your old welded on unit, you would first need to cut the old weld on bracket off of your trailer. Once you've done that, you can switch to a bolt on style trailer jack. You won't be…

view full answer...

Answer 2

Yes, since your current Fulton jack is a bolt-thru style, you can use the Fulton XLT Bolt-Thru Swivel Trailer Jack #F26ZR with your current welded on bracket. You just need to remove the jack from the included bolt-on bracket and mount it to your…

view full answer...

Answer 3

It looks like the jack on the trailer is a Reese swivel jack. The Fulton jack you referenced #FXP15W, should fit in its place no problem. Fulton and Reese are sister companies. However, the bolt holes are 3 inches on center. You will most likely have…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 6

Hey Deven, thanks for reaching out, and good question. For a 12 volt system, the charge controller can handle one 200 watt panel. For 24v systems it can do two 200 watt panels. So while the kit technically is expandable, with your 12v system, the one…

view full answer...

Can a Bolt-On Swivel Jack be Mounted to the Same Bracket as a Weld-On Trailer Jack

Continue Researching