Option to Install Trailer Wiring on 2000 International 3800

Question

Question:

Hi I have a 2000 international 3800 school bus and I need to hook up trailer lights do you have something? Thank you.

asked by: Doug

0

Expert Reply:

While we don't have a custom fit trailer wiring kit that would fit your 2000 International 3800 you could use the part # C59236 to add a 4-way. If you needed a 7-way instead you'd need the part # 37185 as well to convert it to a 7-way.

expert reply by: Jameson C

0

Answer 1

This will depend on the hitch used and the height of the trailer coupler. You want the trailer to be as level as possible. We have a page on calculating hitch height and coupler height to help you find what ball mount would work best. Most light duty…

view full answer...

Answer 2

Actually several of your pictures did make it through! What you have there is the standard/step bumper on your 1979 Chevy C-10. Deep drop bumpers, also called cowboy bumpers, drop way down. If your truck has an 8 foot bed you can use Curt trailer…

view full answer...

Answer 3

The side brackets of the Curt hitch part #C14082 are 9-3/4 inches long so you'd have the clearance needed to fit this on your frame since you have 10 available inches.

view full answer...

Answer 4

Buyers Products Class V hitch #3371801102 fits the cutaway cab and chassis version of the 2003 GMC Savana Van. For the cargo and passenger van version their Class V hitch #3371801100 is the correct fit. I am not sure which version of the base vehicle…

view full answer...

Answer 5

As we have not had a 1973 Ford F-100 in our shop to test fit the available receivers I can only give you the measurements from one of our receivers so that you can see where it will sit on your truck. The Curt Trailer Hitch Receiver #C14082 is…

view full answer...

Answer 6

The Solera 14' Slider (Slide-Topper) in White w/ White Hardware #LCV000163301 comes with everything you need for installation except the #CAM25013 which is an 8 foot length that is shown in the video as you stated. I do recommend getting two of…

view full answer...

Answer 7

The distance from the crosstube to the very end of the receiver is 8 inches for the Curt Trailer Hitch Receiver #C14082.

view full answer...

Answer 8

The best trailer hitch option we have for an International 3800 School Bus is the Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver part #41990-16. This hitch is a great option as it can be bolted-on (once drilled) or welded, the brackets can…

view full answer...

Answer 9

The trailer hitch options for a 1984 Chevrolet C/K Series Pickup all install in the same manor using holes on the underside of the frame. If there are any brackets present they would need to be removed and are most likely not factory therefore the…

view full answer...

Answer 10

There is not a specific size of tape you will need to install a MaxxAir MaxxFan. I recommend using the RV Vent Installation Kit part #CAM25013 which comes with 8' long x 3/4" wide of white butyl tape that should be more than enough for your…

view full answer...

Answer 11

I do have a solution for your 2024 Kia Telluride that has the LED taillights that does allow it to have both a 4-way and 7-way plus install a brake controller but it is not with the #TK74CR which does not work for you based on the LED taillights.…

view full answer...

Answer 12

Both the Curt #C56175 and #C59236 will add a 4-way trailer connector to your 2006 Volkswagen Golf. The main difference between these products is that the #C59236 is a powered tail light converter, which means it gets wired to your vehicle's…

view full answer...

Option to Install Trailer Wiring on 2000 International 3800

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching