Load Stop Recommendation For Yakima JetStream Crossbars

Question

Question:

Hi I was looking for load stops that is compatible with the Yakima JetStream roof racks.

asked by: Garrick T

0

Expert Reply:

The best option for load stops for your Yakima JetStream crossbars are from Yakima:

- Load Stops for Yakima HD Bar, JetStream, FlushBar, and RailBar Crossbars # Y01161

These are designed for the Yakima crossbars and will offer an easy way to secure your gear.

expert reply by: Kyle S

0

Answer 1

I recommend the Rear View Safety Backup Camera System #RVS-772718 for your 2024 Chevrolet Silverado 3500 work truck. This allows you to switch out your rear view mirror for a camera mirror. The small 1" camera can be mounted on your flat bed…

view full answer...

Answer 2

You can't upgrade the pump in the item #AL74000EZ you already purchased but you can add a tank. I have listed three options for tanks below they do not have brackets: 1 Gallon Tank item #F9244 2 Gallon Tank item #F9126 3 Gallon Tank item #F9245…

view full answer...

Answer 3

We have options for you, though the Air Lift WirelessONE Compressor System for Air Helper Springs - Remote and Mobile App - EZ Mount #AL25980EZ is not something that can be used for tire inflation, it is only something you can use for air springs.…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Load Stop Recommendation For Yakima JetStream Crossbars

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching