Size Bolts for Install of Extreme Off-Road Swing-Up Jack w/ Dual Wheels

Question

Question:

What is the size of the mounting bolts…1/2 in? or metric?

asked by: Tim S

0

Expert Reply:

The size of the bolts that come with the Extreme Off-Road Swing-Up Jack w/ Dual Wheels - Sidewind # ORJW500D is M12x 1.75 x 80mm inch.

expert reply by: Jameson C

0

Answer 1

Yes, the Extreme Off-Road Swing-Up Jack w/ Dual Wheels iItem #ORJW500D will work for your T@B 400 Tear Drop Trailer. It looks like your trailer comes with an a-frame jack. You would need to ensure you have enough space on your tongue to accommodate…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 4

Hey George, best solution for you will be to go with an all new jack like the etrailer part #e95YV because Fulton is no longer in business so there isn't a way to get a replacement F2 and none of the other jacks out there use the same bolt…

view full answer...

Answer 5

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 6

I have attached two diagrams below with the dimensions for the XO350 and XO750. Both of these use a bolt on installation so you really only need to know the height of your tongue to see if it is compatible. The #ORJW350D fits 2" to 6" tall…

view full answer...

Answer 7

The ARK #ORJW500D Off-Road Swing-Up Jack weighs in at about 32 lbs. The fully retracted length from the center of the pivot the the bottom of the wheels is 11.22 inches. The same distance when fully extended is 18.89 inches, as you can see in the…

view full answer...

Answer 8

Since we know you have a Lippert torsion axle the correct lift kit part #LC382741 which we have confirmed works with the Lippert square 2,500 lb axle you have on your 2022 Encore ROG 12RK.

view full answer...

Answer 9

The Xtreme Off-Road Swing-Up Jack w/ Dual Wheels #ORJW500D and #ORJW350D are pretty similar with the only differences being the weight capacity, 1,100 lbs vs 770 lbs, and the total travel, 18-3/8" vs 12". Aside from that the mounting…

view full answer...

Answer 10

Hey Jacob, yes the Trailer Valet JXS Drill Powered Swivel Trailer Jack w/ Wheel #TV86FR that you reference does fit the same jack mount as the Trailer Valet 5X Swivel Jack #STC-V211 so if this is what you have already then you could swap it into the…

view full answer...

Answer 11

Here is an image I have from the Xtreme Off-Road Swing-Up Trailer Jack #ORJW750D in zinc which will have the same dimensions as the black Jack #ORJW750BD you are looking at.

view full answer...

Size Bolts for Install of Extreme Off-Road Swing-Up Jack w/ Dual Wheels

Product Page this Question was Asked From

Continue Researching