Does Curt Hitch # 13297 Extend Out Past The Bumper on a 2006 Dodge Durango
Updated 05/30/2013 | Published 05/25/2013 >
Products Featured in This Question
Question:
When this hitch is installed, does it extend out pass the bumper?
asked by: Leslie R
Expert Reply:
We have six different hitches compatible with your 2006 Dodge Durango, including the Curt # 13297 that you referenced. All of the hitches available for your vehicle do extend out a bit past the bumper/fascia.
The diagram shows the Draw-Tite placement in relation to your bumper/fascia, however, all of the hitches will be extremely similar in placement.The picture is of the Draw-Tite # 75162 which does give you a length - this picture is taken on the back of a 2009 Chrysler Aspen, so your Durango may be a little bit longer, however, this can give you a rough idea.
I spoke with both companies, Curt and Draw-Tite, and they both claimed that the receiver will extend out approximately 2-1/2 inches to 3 inches past the bumper/fascia on your Durango.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 600 lbs TW
- 6000 lbs GTW
- 9000 lbs WD GTW
- 2 Inch Hitch
- 900 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Video: Feature Review Replacement Hardware Kit for Trailer Hitches
- Q&A: How to Determine Load Carrying Capacity of 2005 Dodge Durango
- Q&A: Recommendation of Compatible Hitches for the 2005 dodge Durango and Towing Accessories
- Shop: TowSmart Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Replacement Hardware Kit for Trailer Hitches
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Video: 2022 Dodge Durango Draw-Tite Max-Frame Trailer Hitch Receiver: Complete Installation
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV- 2"
- Q&A: How To Reset a Lippert Controller 13398-C2
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommended Trailer Hitch for a 2005 Dodge Durango
- Q&A: Recommended Stabilizer Jacks To Replace PJ-01 Corner Post Stabilizer Jack on 2022 Forest River NOBO
- Q&A: Replacement Components for a Dexter 5100 Pound Axle
- Q&A: How Long Does It Take to Install B&W Turnoverball Underbed Gooseneck Trailer Hitch BWGNRK1020
- Article: Which Hitches are Made in the USA
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)



