Does Curt Hitch for 2017 Volkswagen Golf Alltrack Require Fascia Trimming

Question

Question:

Hey there! The following is very strange.... A reputable hitch installer near me says that to install a Curt Concealed Hitch on my 2017 VW Alltrack would require cutting an OFF-SET rectangular hole in the bumper fascia which would look quite strange. Does that sound correct? Many thanks.

asked by: Bruce E

0

Expert Reply:

When installing the Curt hitch # C11422 on your 2017 Volkswagen Golf Alltrack the only version of the vehicle that would require trimming of the rear fascia is the Sportwagen vehicles with 4Motion. Other models would not require the fascia trimming.

I attached an install video for this for you to check out as well.

expert reply by: Jameson C

0

Answer 1

Aside from the warranty, there's a practical reason for using a Curt Stability Strap, part #18050 or any stability strap. Stability straps reduce the amount of jolting, jostling and all around movement that occurs on non-trailer loads when they…

view full answer...

Answer 2

There are trailer hitches that will fit the 2017 Volkswagen Golf SportWagen of which the Alltrack is one of the options for that vehicle. The hitches available are all Class I hitches though ( #C11422 and #24949 ) and as such are limited to 2 bikes…

view full answer...

Answer 3

Since there are no trunk mounted bike racks that can carry bikes that weigh over 35 lbs you'd have to look into a hitch mounted e-bike rack like the Thule EasyFold XT part #TH903202 which was designed for the heavier e-bikes as it has a higher…

view full answer...

Answer 4

Curt trailer hitch #C11422 (fascia trimming not required) fits the following vehicles: 2017 - 2018 Volkswagen Golf Alltrack 2017 - 2017 Volkswagen Golf SportWagen 2015 - 2016 Volkswagen Golf SportWagen TDI models 2015 - 2016 Volkswagen Golf…

view full answer...

Answer 5

Due to the weight of your e-bikes, the only solution that we can safely recommend would be to use a trailer hitch, like the Curt Class I Hitch, #C11422, and a hitch mount bike rack that can handle the weight of your bikes and the fat tires of your…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 9

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Answer 10

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 11

Hey Scott, thanks for reaching out! We don't have an installation video of the Curt T-Connector #C56391, but we do have one of the Tekonsha T-One #118730 on a 2017 Volkswagen Golf Alltrack that I'm linking for your reference. The installation…

view full answer...

Does Curt Hitch for 2017 Volkswagen Golf Alltrack Require Fascia Trimming

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching