Troubleshooting Landing Gear Not Coming Up All the Way
Updated 09/03/2021 | Published 08/30/2021
Products Featured in This Question
Question:
strange problem, both landing gear go down fine. motor side powers up fine, other side stops going up as soon as pressure is off it. it doesnt release enough to pull the pin, but if i place wood under it in a fashion that i can get a jack under the leg and put pressure on it, it will continue to raise
asked by: Tim P
Expert Reply:
I spoke to my contact at Lippert, he said it sounds to him like the threaded rod inside the follow leg of your landing gear was the issue. He did not think it was the gears themselves.
Lippert does not sell the threaded rod separately, so you will need to replace the whole jack. The follow legs, such as the Replacement 5th Wheel RV Landing Gear Follow Leg w/ Snap Pin for RVs # LC179014, can be purchased separately depending on the current landing gear you have.
Product Page this Question was Asked From
Lippert Venture Lead Leg Repair Kit for 5th Wheel RV Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Lippert
more information >
Continue Researching
- Search Results: rv landing gear and motor
- Search Results: atwood landing gear motor
- Search Results: camper jacks
- Search Results: accessories and parts
- Shop: Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg w/Snap Pin
- Shop: Lippert HD 6500-lbTuson 5th Wheel RV Landing Gear Motor
- Shop: Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Shop: Replacement Lead Leg for Stromberg Carlson Landing Gear - 33-1/2"
- Q&A: Recommended Replacement Lead Leg for Bent Leg on Jayco 5th Wheel Trailer
- Video: Replacement Lead Leg for Stromberg Carlson Landing Gear: The Breakdown
- Video: Complete Breakdown of the Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Video: Lippert Components Trailer Jack LC179013 Review
- Video: Ultimate Overview of the Replacement Lead Leg for Keystone Montana 5th Wheel Landing Gear
- Shop: Replacement 5th Wheel RV Landing Gear Follow Leg w/ Snap Pin for RVs
- Shop: Replacement Motor with Clutch for Lippert Ground Control 2.0 Electric Leveling System
- Shop: Motor and Switch Kit for Stromberg Carlson Landing Gear - 5,500 lbs
- Search Results: trailer hitch
- Shop: Trailer Hitch
- Video: All You Need to Know About the Landing Gear Set
- Video: In-Depth Review of the Landing Gear Set
- Search Results: trailer jack
- Shop: Trailer Wiring
- Search Results: rv air conditioners
- Video: The Low-Down on the Replacement Motor for Stromberg Carlson Electric Landing Gear
- Shop: Suspension Enhancement
- Shop: Brake Controller
- Shop: Gooseneck Hitch
- Shop: Fifth Wheel Hitch
- Shop: Camper Tie-Downs
- Q&A: Replacement Parts or Assembly for Landing Gear of 1998 Gulfstream Innsbrook
on Accessories and Parts
