Do You Have Any Tie-Downs I can Use for My Front Pucks on My 2018 RAM 2500 with Prep Package?

Question

Question:

I want to use the front puck for a tie down so I will have a 4 point tie down. Do you have anything I can use in the front puck holes for tie downs. 2018 Ram 2500

asked by: Dan L

0

Expert Reply:

If you are looking for front puck tie-downs, the best bet is the Curt Safety Chain Loops for Factory Ram Underbed Gooseneck Trailer Hitch # C60617. I confirmed with Curt that these should work with your front pucks as well.

expert reply by: Bob C

0

Answer 1

Yes! For the safety chain loops only for the 2014 Ram 3500 with factory prep package you will need #C60617. They also come with the 4 pins you will need.

view full answer...

Answer 2

The difference between the Curt #C94ZR and the Curt #C60617 is the material that the two anchors are constructed from; while they will both fit in the rear pucks on your 2018 Ram 2500, the 2021 and newer Ram HD trucks have upwards of 36,000-lbs…

view full answer...

Answer 3

We have pulled the Fulton Chains part #FCHA0070324 before and test fit them with the safety Curt safety chains part #C60617 and found that the two easily fit together. The chain link is 1/2 inch in diameter.

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Hey Micah! Pacbrake has actually been around for a long time, more than 60 years. We have had customers ask for these air bags in the past, and we've seen them on vehicles coming in. Until now, Firestone has been the go to since their quality is…

view full answer...

Answer 11

Hey Nelson, so you would need two separate systems since a supplemental braking system can only be used with a towed vehicle and a trailer brake controller can only control trailer brakes. Main difference is a supplemental braking system is designed…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Do You Have Any Tie-Downs I can Use for My Front Pucks on My 2018 RAM 2500 with Prep Package?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching