Search: electric brake conversion kit   >  

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If…

In order to find if the Dexter 10" Hub-and-Rotor Assembly #K08-435-05 will fit your 2000 620 Ranger boat trailer you will need some additional information. This assembly is designed to fit a 3,500 lb axle with the standard #L68149 inner and…

You will need a brake controller, a 7-Way adapter and a brake control wiring adapter to complete the installation of trailer brakes on your 2002 Dodge Ram. Start by plugging in the brake control adapter, item #3020-P, into the OEM harness located…

The kit you are looking for is the part #BRKH10B which is nuts and lock washers needed to install the brake assemblies part #AKEBRK-35-SA that you referenced. The nut size is 7/16-20.

All of our leaf springs like the 4-Leaf Double-Eye Spring for 5,000-lb Trailer Axles - 25-1/4" Long #e28SR are sold individually. For a single axle you would need two.

In order to switch from slipper to double eye springs you'll need new hangers which are going to dictate your height so if you're looking to maintain the same height, you'd want to choose new hangers which are the same height as your…

I did not see where you mentioned what electric over hydraulic actuator you are using but if it is the HydraStar Marine Electric Over Hydraulic Actuator part #HBA16 that you referenced then the first thing I recommend you check is that you are using…

The 4-bolt mounting pattern of 7-inch brakes is the same as for 10-inch brakes; both use bolts/holes spaced apart by 2-7/8-inches on center. Moving to larger brakes will naturally require new hubs and these new hubs must use the same set of bearings…

If a brake line is opened on a braking system is common practice and recommended to bleed the entire system. There's a high possibility air entered the system when the line was opened.

You will need several items to add electric brakes to your Carry-On Utility trailer. Starting with the trailer you will need a hub and drum that matches the bearings and seal on your trailer spindle and your wheel bolt pattern. The only way to be…

When installing the Titan Zinc-Plated Brake Actuator - Drum - Multi-Fit Ball - Bolt On - 7,000 lbs #T43397007K you need to leave the brass fitting that is on the end. This is the orifice connector which ensures proper fluid flow characteristics so it…

I attached a link to the right that contains detailed installation instructions for the Titan Zinc-Plated Brake Actuator #T43397007K that you can use as a guide to install this coupler on your 1994 Maxum 20 foot boat trailer.