Are There Different Height Timbren Kits that Fit 2005 Chevy Astro Van
Updated 08/05/2021 | Published 08/03/2021
Products Featured in This Question
Question:
I have a 2005 Chevrolet Astro 2WD Passenger van. I would like to use the Timbren SES to reduce the sag of the rear suspension under load and while towing a trailer. I am also going to lift this van 2-3. I would like to reduce the number of spacers used to close the gap between the bump stop mount and the frame. What is the spring height distance between the springs of TGMRASTB and the TGMRASTBHD? What is the overall installed height difference between the two kits? Thank you.
asked by: Kevin M
Expert Reply:
There is no height difference between the Timbren kits that fit your 2005 Chevy Astro Van part numbers # TGMRASTB and # TGMRASTBHD. One would not be better suited for a lifted van to not use spacers. The height is 3-3/4 inches.
Product Page this Question was Asked From
Timbren Rear Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Standard Duty
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Recommended Weight Distribution System for 2004 Chevy Avalanche Towing 4000 lb Trailer
- Q&A: Recommended Weight Distribution Hitch for 3500-lbs Trailer
- Q&A: Recommended Trailer Hitch Receiver for a 2004 Chevy Astro Cargo Van
- Q&A: Recommended Weight Distribution System for a 4,000 lbs Trailer
- Q&A: Proper Mounting Location for Side Marker Lights on a Trailer
- Q&A: Where Should the Ground Wire for a Brake Controller Install Go
- Q&A: Recommended Interior and Exterior LED Lighting for Enclosed Box Trailer