Similar Trailer Light to BUL101CB with Chrome Trim

Question

Question:

The detail for the BUL101CB, says grommet is available separately, but doesn’t actually list the complementing grommet. Too confusing.

asked by: Paul H

1

Helpful Expert Reply:

So we don't have a chrome or stainless flange for the # BUL101CB so the closest option might be the part # UCL60CB which is a similar 3 inch diameter clear utility light with a chrome flange.

expert reply by: Jameson C

1

Paul H.

6/23/2021

The detail for the BUL101CB, says grommet is available separately, but doesn’t actually list the complementing grommet. Too confusing.

Jameson C.

6/23/2021

The grommet to use with the # BUL101CB is the part # A45GB.

Answer 1

Hey Mariana, There isn't a guide to tell us the puck lights that were installed in your 2016 Jayco Jay Feather Series X23B travel trailer, but we can take some measurements to determine what could be a compatible replacement. I'll just need…

view full answer...

Answer 2

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 3

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hi Thomas, I've put together a few different 12V LED 4 1/2" diameter puck light options for you so you can find the best replacement for your light! Since lights can mount in different ways, I've included puck lights that are…

view full answer...

Answer 10

Hi Bill! You will need to completely replace the system since you have old Dometic R410a units on your Monaco. Everything switched to R32 refrigerant following new EPA regulations in 2025, and the new systems are not backwards compatible. For a…

view full answer...

Answer 11

Hey Lee! The Victron parts can get pretty confusing. The Victron Orion-Tr #VN75ZR is only designed to be a power supply for DC loads, not for battery charging. You do not want to use this converter to charge any type of battery. To charge your…

view full answer...

Similar Trailer Light to BUL101CB with Chrome Trim

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching