Roof Rack And Tent Combo For 2000 Honda CR-V

Question

Question:

Hi, Thanks for taking my question. The weight bearing of this product says 140lbs. Is this the dynamic weight? The goal is to put a 108lb roof top tent on my crv. Then the added weight of myself, spouse and gear would be more around 400lbs added to the 108lb tent weight. So, just over 500lbs static weight. My crv does Not have any rails. Please let me know the deals and your suggestions. Sincerely, Andrew

asked by: Andrew

0

Expert Reply:

If you're wanting to get the Inno roof rack system on your 2000 Honda CR-V, you will need the Inno Aero Crossbars # INXB123-2, Inno Through Feet # INXS250 and the custom Fit Kit # INK146. These have a dynamic weight capacity of 165 lbs. This Yakima SkyRise Tent # Y07437 requires a minimum of 165 lbs of dynamic weight capacity.

Dynamic is the weight in motion and static is the weight when sitting still. So you will be good to put a Yakima tent on top.

expert reply by: Adam E

0

Answer 1

The wheel protectors that come with the Konig Chains part #TH01594247 are optional but I strongly recommend using them if you value your wheels! You'll just need to put them in the best locations that will protect the wheels. There isn't a…

view full answer...

Answer 2

Hi Jordan, Ok, I think I can clear this up for you, and just to get the final answer for you, the maximum COMBINED weight a cargo carrier and its luggage can weigh in your current setup is 175 lbs (also, apologies for the caps but they don't…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 10

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Roof Rack And Tent Combo For 2000 Honda CR-V

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching