Replacement Control Board for HappiJac Jack System with Corded Controller

Question

Question:

I have old school happijacks on my camper with a corded remote. I believe the control board is bad. Will the current cordless board LC733540 replace what is currently installed on my camper?

asked by: Scott M

0

Expert Reply:

I was able to confirm with my contact at Lippert that you can use the Replacement Circuit Board w/ Wireless Remote for HappiJac Electric Truck Camper Jack Systems # LC733540 to replace the circuit/control board on your corded HappiJac system. You can also use the Replacement Circuit Board for HappiJac Electric Truck Camper Jack Systems # LC733513 if you just want the circuit board and don't need the remote replaced.

expert reply by: Erik B

0

Answer 1

Don't worry about it Gordon your picture ended up coming through and it was a big help. It appears for a replacement remote you're just going to need the Replacement Remote Controller for Wireless HappiJac Electric Truck Camper Jacks #HJ54ZR;…

view full answer...

Answer 2

For the 4500 Happijac setup the replacement motor is the part #LC759927 but the 4160 motor has been discontinued. Best option is probably to replace the entire setup at this point since a motor replacement isn't available. For that you would want…

view full answer...

Answer 3

The replacement motor kits that you are seeing will not work with the 4800 series jacks. The 4800 series, uses the 182522 motors and we do not carry them. The 4800 series was discontinued, making it more difficult to find replacement parts. With the…

view full answer...

Answer 4

The Replacement Remote Control for HappiJac Electric Camper Jack Systems #LC723915 works with logic boards 723914 and 733513. If that matches your circuit board then you can use the remote. You will also need #LC149557 for pairing. If you have one of…

view full answer...

Answer 5

Well that stinks to hear; I'm sorry someone was lousy enough to steal from you. And while we do have an option for you, the older wired remote is not available as a replacement part. So what you would need to do instead is replace the circuit…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 12

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Replacement Control Board for HappiJac Jack System with Corded Controller

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching