Replacement Brake Assemblies for 2003 Fleetwood Bayside

Question

Question:

I have a 2003 Fleetwood bayside pop up trailer. GVWR is 3770 lb., Wheel size is 13x4. 4 bolt pattern for electric brake drum assembly. Can you tell which self adjusting drum assemblies would be a suitable replacement?

asked by: Russell R

0

Expert Reply:

Based on what you listed it sounds like your trailer has 2k axles so the correct left and right brake assembly kit would be the part # 23-47-48.

expert reply by: Jameson C

0

Answer 1

I would be happy to help, but unfortunately we do not have a breakdown of the specific tire size that will fit on your 2002 Coleman Fleetwood Fairlake Pop Up Camper. The Goodyear Endurance line of trailer tires that is made here in the USA only goes…

view full answer...

Answer 2

There is no need to unplug a brake controller when it's not in use and typically something like the Curt Reflex C51130 shuts off automatically after a certain time period-usually around 15 minutes. These won't drain your battery when sitting…

view full answer...

Answer 3

Since the Curt Echo #C51180 can't be locked in any way to your tow setup I would recommend removing it as often as you can to prevent theft of it. Now if you were to leave it connected to your tow vehicle for an extended period of time it would…

view full answer...

Answer 4

Hello Nathan, thanks for reaching out. To answer your question, the 1/8" difference is not going to make a difference when replacing your leaf springs. That said, leaf springs are not a custom fitted part you can look up using our fit guide.…

view full answer...

Answer 5

Based on your VB0568 part number you would need the Ventline Old Style Rounded Dome Trailer Roof Vents #BV0554-01 for white, or #BV0554-03 for smoke. These lids have a continuous hinge so I recommend doublechecking your design just to be sure that it…

view full answer...

Answer 6

The correct replacement cover for your Ventline Northern Breeze VB0568 Roof Vent is the Vent Cover for Ventline Old Style Rounded Dome Trailer Roof Vents #BV0554-01 for white, or #BV0554-03 for smoke. I have attached a couple of videos for you to…

view full answer...

Answer 7

The Replacement Override Plugs for Lippert Electric Trailer Jack #LC733924 fits the standard 1" plug hole, though it is specifically designed to fit the Lippert Electric Trailer Jack #LC285318 so that's the only jack I can guarantee it will…

view full answer...

Answer 8

The head of the B&W Companion OEM 5th-Wheel Hitch item #BWRVK3300 is 13" in diameter. You will want to use the Reese Lube Plate 12" Diameter item #RP83001. This 12 inch diameter plate works great on higher capacity hitches like your…

view full answer...

Answer 9

Generally speaking, the lube plate will need to cover the skid plate on the 5th wheel hitch. There are some pin boxes out there that will recommend a specific lube plate but most of the times this classification will be from the 5th wheel hitch…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Replacement Brake Assemblies for 2003 Fleetwood Bayside

Product Page this Question was Asked From

Continue Researching