Recommended Spare Tire Carrier for 15 Spare Tire on R-Pod 182G

Question

Question:

I would like to install a spare tire carrier on my 2017 Forest River R-Pod 182g. It looks like the tongue is the best place. Can you confirm that? And which bracket would hold the 15 tires that come with the 2017 R-pod? I watched a review of one for tires up to 14, but they put bigger tires on in 2017. Thanks, learning a lot from your site!

asked by: Susie B

0

Expert Reply:

Looking at the setup of a 2017 Forest River R-Pod 182G, you won't be able to put anything on the rear of the trailer so your only real option is going to be on the trailer A-frame. I recommend using the Extra Offset Trailer Spare Tire Carrier by Dutton-Lainson # DL22145, because it can handle your 15" wheels and will fit on a variety of trailer frame sizes. You will want to confirm that your trailer's frame is no taller than 5" and thicker than 3" to ensure this will fit.

I've linked a short review video of this part for you to check out, as well. If your trailer frame is larger than that, let me know and I can see if there is a better option.

expert reply by: Erik B

0

Answer 1

With the typical ST235/75R15 tire having a diameter of 28.8 inches (roughly), the Westlake ST205/75R15 Radial Trailer Tire - Load Range D #LHWL300 at a 27.1 inch diameter, will definitely fit your 2017 R-Pod 177. These will have a maximum capacity of…

view full answer...

Answer 2

Most single step RV steps are either 20 inches wide or 24 inches wide. So depending on which you have now you could use the part #SMFP-2120 for a 20 inch wide step or part #SMFP-2100 for a 24 inch wide step.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Recommended Spare Tire Carrier for 15 Spare Tire on R-Pod 182G

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching