Bolts Needed to Install a Hitch on a 2011 Chrysler Town and Country
Updated 01/28/2021 | Published 01/25/2021
Question:
i brought a trailer hitch for my 2011 chrysler town and country during install i broke 3 bolts could you tell me the dia, thread and length
asked by: Kenneth Z
Expert Reply:
It looks like the hitches for the 2011 Chrysler Town and Country use the bolts that are already drilled into the vehicle.
I've linked to a video installation of the Draw-Tite Hitch, part # 75579, so you can see how it works.
As for the size of the bolts, looking at the installation instructions for this hitch (also linked below), it looks like they are a mix of M12 and M10 bolts. You can find these at your local hardware store.
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Does Draw Tite Hitch DT75GR Fit 2025 Mercedes GLE 450
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Rear Bumper Clearance for the Draw-Tite # 76025 on a 2012 Honda Odyssey
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Where is the Cold Side Brake Wire on My Jeep Grand Cherokee for Installing Demco Stay-In-Play?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Monitor for a Voyager WVCMS130AP Camera
- Q&A: 3 Camera Multiplexer Recommendation for RV with 3 Cameras
- Article: Dealer Spotlight - Croft Trailer and Hitches
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: My Trailer Hitch Doesn't Fit