Finding Someone to Install Roadmaster Invisibrake

Question

Question:

If I purchase the Roadmaster invisibrake can you refer a company for installation in the Cleveland Ohio area?

asked by: Bruce E

0

Expert Reply:

While we don't have a specific shop we can recommend for you to have the InvisiBrake # RM-8700 installed on your vehicle we can help you with the process. You'll want to find a local RV dealer who does installs and ask them if they would do it (most likely they will) and if not they'd have someone reputable they can recommend.

expert reply by: Jameson C

0

Answer 1

It sounds like you need the Roadmaster Even Brake 2nd Vehicle Kit part #RM-98400 since the serial number is lower then 27,496 you can use this kit as confirmed by Roadmaster.

view full answer...

Answer 2

The difference between the Roadmaster Even Brake 2nd Vehicle Kit #RM-98400 and the #RM-98450 comes down to a change in the Even Brake system itself. The correct 2nd vehicle kit will be determined by the serial number on your Roadmaster Even Brake…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Finding Someone to Install Roadmaster Invisibrake

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching