Installing a Redarc Trailer Brake Controller on 2021 Jeep Wrangler with Brake Pedal Sensor
Updated 11/18/2020 | Published 11/15/2020
Products Featured in This Question
Question:
I have a 2021 jeep wrangler it has a brake pedal sensor. how do you connect the redarc. brake controller to it. It has three wires
asked by: Terry H
Expert Reply:
The Redarc Tow-Pro Elite # RED44FR or the Liberty # RED24FR with harness # RED69FR will install in the same way. If you have the factory tow package, you simply connect harness # 3073-P and then cut the harness matching color for color If you do not have the factory tow package then you will need to test the wires you referenced using a circuit tester like # PTW2993. You will connect the red wire of the harness to the factory wire that only shows power when the brake pedal is pressed.
The black wire of the harness goes to 12v power, the white to ground, and the blue wire is the power output connection that leads to your 7-way connector's 5 o'clock pin. I've attached an installation help article to assist.
Product Page this Question was Asked From
Redarc Tow-Pro Elite Brake Controller - Dash Knob - Off-Road Mode - Up to 3 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Splice-In
- Dash-Mounted Knob
- Behind-Dash
- Up to 3 Axles
- Indicator Lights
- Single Trailer Only
- Redarc
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: 4 to 7 pin adapter
- Search Results: redarc diode
- Search Results: redarc trailer brake controller
- Search Results: red arc liberty
- Shop: Brake Controller
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Video: Comprehensive Review: Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness
- Video: A Closer Look at the Redarc Encapsulated Power Diode for Tow-Pro Brake Controllers
- Video: Detailed Breakdown of the Buyers Products Trailer Connector Adapter
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Suspension Enhancement
- Q&A: Recommended 7-Way Connector for a 2023 Jeep Wrangler Unlimited w/out the Factory Towing Package
- Q&A: Where To Connect Red Wire Of Redarc Tow-Pro Liberty To 2016 Kia Sorento W/ Adaptive Cruise Control
- Q&A: Troubleshooting Pollak Trailer Connector Adapter Not Working With Kioti DK5010 Tractor
- Q&A: Recommended 7-Way Connector for a 2024 Jeep Wrangler Unlimited w/out the Tow Package
- Q&A: Brake Switch Signal Without Tapping into Factory Wiring On 2021 Toyota Highlander For Brake Control
- Shop: Vehicle Tow Bar Brake System
- Shop: Buyers Products Trailer Connector Adapter - 4-Way to 7-Way RV and 4-Way Flat
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - Up to 2 Axles - Proportional
- Q&A: Installing Brake Controller on 2021 Jeep Wrangler Rubicon without Tow Package
- Search Results: trailer hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: How to Choose a Trailer Brake Controller
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer wiring
on Trailer Brake Controller
