Where Is The Connector Used To Install Hopkins Trailer Hitch Wiring Harness On 2003 Subaru Baja

Updated 10/26/2020 | Published 10/23/2020

Question:

I have located the wire under the car but dont know if there is a cap to be pulled off?

asked by: Andre G

Expert Reply:

To install a custom vehicle wiring harness like the Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # HM11143875 onto your 2003 Subaru Baja you will need to located the 6 pin connector that is located underneath the passenger side rear of the vehicle, near the vehicle vapor canister.

A few reviews did mention that there is a cap on the connector on the vehicle that will need to be removed prior to installing the wiring harness connector.

I attached the video review of the Hopkins Plug-In Simple Vehicle Wiring Harness # HM11143875 for you.

I reached out to Hopkins directly and if you can send a picture of the cap that is stuck on the vehicles connector, they will be able to take a look and give some tips and tricks to get it off.

expert reply by: Samuel C