Slide Out Motor Replacement for Fleetwood Southwide 2006 with Part Number 954925

Question

Question:

Hello I have a 2006 fleetwood with a slide out motor part number 954925 that needs to be replaced. Will motor LC368417 work? I have done some searching and it looks like your motor may be compatible. Please let me know thanks.

asked by: Tyler

0

Expert Reply:

Yes the part # LC368417 that you referenced is the correct replacement motor for you based on the part number you listed of 95425.

expert reply by: Jameson C

0

Answer 1

Per our technical contact at Lippert Components they said that on their landing gear legs such as the follow leg part #LC179014, the outer tube has two pinch points that are intended to prevent the inner tube from extending too far. The pinch points…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

The Longview Custom Towing Mirrors part #LV97RR are the best towing mirrors for a 2018 Chevrolet Colorado because they are custom which means they will have the tightest fit and least vibrations. Check out the review video I did on them on a slightly…

view full answer...

Answer 9

Yes the part #LC368417 that you referenced is the correct replacement motor for you based on the part number you listed of 95425.

view full answer...

Slide Out Motor Replacement for Fleetwood Southwide 2006 with Part Number 954925

Product Page this Question was Asked From

Continue Researching