Availability of Replacement Rear Happijac Qwik Load Turnbuckles

Question

Question:

Can longer hooks be used to reach frame mounts on 1997 f350 crew with Lance 1997 Squire 8800? Front hook of 11-inch is way too short. Are longer hooks available with purchase of Qwik Loads?

asked by: James F

0

Expert Reply:

Did you try the longer rear hooks in the front position of the # LC182895? If those were long enough they are available separately with # LC182896.

expert reply by: Jameson C

0

Answer 1

The only option that would work with your 2022 Ram 3500 that wouldn't require you to remove the running boards would be the HappiJac Camper Tie-Downs #LC236326-205221. The front anchors would sit between the cab and bed and rear anchors would…

view full answer...

Answer 2

Hey Don, so I don't see why the shafts of the HappiJac Qwik-Load Turnbuckles for Camper Tie-Downs #LC182895 couldn't be cut down shorter but we don't have a specific number on how much shorter it could go. If you have a length in mind…

view full answer...

Answer 3

Assuming the tie down locations of your flat bed truck are built strong enough there's no reason you couldn't use turnbuckles like the Happijac Original Turnbuckles part #LC182901 that you referenced. Or for the spring loaded version the part…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 12

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Availability of Replacement Rear Happijac Qwik Load Turnbuckles

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching