How Many Lights Come with STL59RB

Question

Question:

Is there one or two LED tail lights in this package? STL59RB

asked by: Gary

0

Expert Reply:

The Thinline LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 9 Diodes - Red Lens # STL59RB is a single light bar. If you needed both driver and passenger side, you would want to order 2 of these lights.

expert reply by: Erik B

0

Answer 1

It sounds like the previous lights on your trailer used the mounting hardware for the ground. Your new LED light assemblies have a separate ground wire, which should be attached to a clean, bare metal surface. You will want to make sure that there is…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Hey Cindy, thanks for reaching out. We may have an extension that will work for you. It will help to know exactly how long of an extension you are needing as this will be one of the main deciding factors. Let me know how long you need it to be in the…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hey Todd, welcome back! The Curt Flex Air part #LC369535 that you referenced will be a great option for a cushioned pin box that will make a noticeable difference in ride quality. This does not sit 6 inches taller than your current Rota Flex so there…

view full answer...

Answer 10

Hey Matt, I was able to track down a set of install instructions for the PullRite SuperGlide Quick Connect Capture Plate for MORryde Cushioned Pin Boxes #PUL76RR that I saw you ordered in your order notes. I attached the pictures below this message…

view full answer...

Answer 11

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 12

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…

view full answer...

How Many Lights Come with STL59RB

Product Page this Question was Asked From

Continue Researching