Is Timbren Suspension Enhancement for 2019 Nissan Frontier Compatible With Lifted Truck

Question

Question:

Hello, is this compatible with a lift kit? I drive a 2019 Nissan Frontier 4x4 Crew Cab.

asked by: Dan H

1

Helpful Expert Reply:

You can install the Timbren Rear Suspension Enhancement System # TTORTUN4L on your 2019 Nissan Frontier with a suspension lift.

In order to do so, you need to add the appropriate amount of spacers that will allow you to wind up with between 1/2" and 1-1/2" of space between the spring and its contact point above the axle. The spring itself measures 3-3/4" tall so you can use that as a guideline to determine how many of the following spacers you will need:

- Timbren 1" Spacer # A25723-90AH00

- Timbren 1/2" Spacer # TA25722-90P00

I have added a link to a video review for you to check out as well of the Timbren Rear Suspension Enhancement System # TTORTUN4L.

expert reply by: Kyle S

1

Answer 1

Hey Rudy, thanks for the information! The Firestone Ride-Rite Air Helper Springs item #F2558 is designed for the factory suspension on a 2019 Nissan Frontier SV. The brackets will work with up to a 1" suspension lift without the need for…

view full answer...

Answer 2

Hey Josh, From what I can tell from what you're describing, what you need is the Roadmaster Brite-Lite Wiring Converter #RM-732. This will allow your trailer's brakes and turn signals work in tandem with your Isuzu's.

view full answer...

Answer 3

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…

view full answer...

Answer 4

Hello again Ed! You probably ended up outside our fitguide with some of the Timbren the parts you were looking at. The Timbren SES severe service kit is designed for constant loads like a truck bed camper or salt spreader. Regardless, a severe…

view full answer...

Answer 5

Hey Ryan, the Timbren Active Off Road Bumpstops part #TABSNXF do not require a spacer kit on lifted vehicles like your 2019 Nissan Frontier but it's not needed since this is a bumpstop replacement.

view full answer...

Answer 6

Hey Richard! Congrats on your new hobby! I've listed my recommendations below. 1. We don't carry shocks but to upgrade your rear suspension, you'll want the Firestone Ride-Rite Air Helper Springs item #F2558. These air bags have a 5,000…

view full answer...

Answer 7

To determine if lift spacers are needed to install the Firestone Ride-Rite Air Helper Springs #F2558 on your 2018 Nissan Frontier SV 4x4, you'll need to measure the distance between the top and bottom mounting brackets (see photo). Make sure your…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Is Timbren Suspension Enhancement for 2019 Nissan Frontier Compatible With Lifted Truck

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching