Carrying 4 Bikes on 2011 Toyota Corolla

Question

Question:

Corolla 2011 the hitch for this I can used for my racks for my 4 bicycle

asked by: Jesús L

0

Expert Reply:

The Curt Class I hitch, part # C11265 is a fit for a 2011 Toyota Corolla. The bike rack and hitch manufacturers all agree that no more than 2 bikes should be carried on a Class I hitch. Adding a third and fourth bike will apply too much leverage to the hitch, damaging the hitch of its attachment points to the vehicle.

The most cost effective way to carry 4 bikes would be to use a 3 bike trunk mount rack like the Saris Guardian, part # SAR43FR and carrying the fourth bike on the roof after installing a roof rack like # SR1002 along with a bike rack like # TH598004.

I've linked to product demonstration and install videos for the products I recommended.

expert reply by: Mike L

0

Answer 1

Unfortunately it will not Bill but congrats on the car! There's been two generation changes with big redesigns on the Corolla so the older hitch isn't going to be transferable. To add a hitch to your 2025 Toyota Corolla LE, I recommend the…

view full answer...

Answer 2

To tell you the truth Gary, this sounds like a very familiar problem. Especially for a slightly older car like a 2009 Corolla it is quite common the weldnuts under the vehicle to get rusty and corroded. I will add that it is highly uncommon, I would…

view full answer...

Answer 3

For carrying a bike rack with a hitch installed on a vehicle I recommend going with the Draw Tite hitches instead of the Curt as Curt requires you to use a stabilizer strap any time you carry a non-supported load like a bike rack like the Swagman…

view full answer...

Answer 4

For your 2006 Toyota Corolla Sport, I recommend using the Curt Trailer Hitch Receiver part #C11265. This hitch hangs down lower on the vehicle in comparison to the Draw-Tite Sportframe Trailer Hitch Receiver part #24913. As you can see in the…

view full answer...

Answer 5

Hello Mike, thanks for reaching out. We do offer a few different hitches for the 2026 Subaru Crosstrek, the Curt #C22MJ, the Draw-Tite #76209 and the EcoHitch #EH57CR. All 3 of these hitches place the receiver in virtually the same position beneath…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Starting with a hitch for your 2008 Toyota Corolla S, I recommend the Curt Trailer Hitch Receiver #C11265. It features a bolt on installation and has a max tongue weight of 200 lbs for accessories. Since Class I is the only option available you are…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 10

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...