Best Trailer Hitch Receiver for a 2006 Toyota Corolla Sport
Published 03/25/2018 >
Question:
Which of the Curt or the Draw-Tite will best fit a 2006 Toyota Corolla S Sport version with extra trim around the car There may or may not be any difference in the rear dimension from the frame mounting points to the bottom of the trim and bumper bottom and top of the cross bar of the hitch. Regards
asked by: Bob
Expert Reply:
For your 2006 Toyota Corolla Sport, I recommend using the Curt Trailer Hitch Receiver part # C11265. This hitch hangs down lower on the vehicle in comparison to the Draw-Tite Sportframe Trailer Hitch Receiver part # 24913. As you can see in the attached photo, this hitch will fit the sport model perfectly and will not require any trimming of the rear bumper fascia or ground effects.
I have attached an installation video on a similar 2007 Toyota Corolla for you. If you can tell me what you will be using the hitch for I would be glad to make some additional recommendations for you as well.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Search Results: trailer hitch
- Shop: Trailer Wiring
- Search Results: threaded pin style hitch anti~rattle
- Search Results: hitch adapter 1 1 4 to 2 trailer hitch
- Search Results: adapter
- Search Results: hitch anti~rattle
- Video: Setting up the Curt Trailer Hitch Receiver on a 2017 Toyota Corolla
- Video: Review of CURT Hitch Anti-Rattle - Anti Rattle Hitch Clamp 2-1/2 Inch Trailer Hitch - C34FR85HY
- Shop: Curt Anti-Rattle Hitch Clamp for 2-1/2" Trailer Hitches
- Shop: etrailer Anti-Rattle Hitch Collar for 2.5" Hitch Receivers
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt Class I Drawbar - 5/8" Rise, 1-1/4" Drop - 6-3/4" Long - 2,000 lbs
- Shop: Master Lock Hitch Receiver and Coupler Latch Lock Set - Padlock - 1-1/4" and 2" Hitches
- Shop: Curt Trailer Hitch Receiver Adapter - 1-1/4" (Class II) to 2" - 6" Long
- Q&A: Can Dirt Bike Carrier be Used on a 2014 Toyota Corolla LE
- Q&A: Comparing the Receiver to Bumper Clearance for Trailer Hitch Receivers for a 2015 Toyota Corolla
- Video: What to Know About the Rhino-Rack Vortex Roof Rack
- Shop: Roof Rack
- Video: A Closer Look at the etrailer Anti-Rattle Hitch Stabilizer for 2" Hitches
- Q&A: Will the Pollak 7 Pole to 4 Way Connector Adapter Work w/a Honda Passport?
- Video: Ultimate Overview of the Curt Trailer Hitch Receiver Adapter
- Video: The Low-Down on the InfiniteRule Trailer Coupler Lock
- Video: Review of etrailer Hitch Anti-Rattle - Anti-Rattle - e38FV
- Q&A: Trailer Hitch and Wiring Recommendation for 2005 Toyota Corolla
- Q&A: How Far Below the Bumper Does the Bottom of the Curt # C11265 Hitch Sit on a 2005 Toyota Corolla
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer wiring



