Pacer Performance 3rd Brake Light Logic Module Wiring

Updated 03/17/2020 | Published 03/15/2020

Question:

for use in 2019 Chevy colorado. I have new go fast camper installed now and have a pig tail off the center mounted brake light along the drivers side rear of the camper. If I use this module to by pass the blinking light when turn signal used, do I have to wire both of the leads if only using the left side to power the light. In other words do I have to run a wire from this logic module to the right light as well?

asked by: Terry R

Expert Reply:

Whenever wiring Pacer Performance 3rd Brake Light Logic Module # # PP20-702 the yellow wires must go to each brake/turn signal and the green wire goes to the 3rd brake light. The reason why you need to hook both up is because the logic module filters out the turn signals and applies only the brake, so wiring only one may cause it to not work properly.

expert reply by: Robert C