Are the Spring-loaded Barrels Part # TLS9000 Available Without the Chains

Question

Question:

Is it possible to buy just the spring loaded barrels without the chain or turnbuckles?

asked by: Ben

0

Expert Reply:

While the TorkLift Basic SpringLoad Turnbuckles for Camper Tie-Downs - Qty 2 part # TLS9000 are awesome to prevent the overloading or twisting we can sometimes get. They are not available as just the barrels. They are sold as a kit to make it easy to add to your current setup.

expert reply by: Randy B

0

Answer 1

If your Ranger has the 6 foot bed, with no running board or step under the truck bed and an factory equipped hitch with a crosstube that's open on the sides or an aftermarket hitch with side plates that measure LARGER than 4 x 4 inches, the…

view full answer...

Answer 2

The TorkLift Basic SpringLoad Turnbuckles #TLS9000 actually have an adjustable length of 9 to 13 inches. Just the spring-loaded barrels measure about 4 inches. The two included chains are 24 inches long and 1/4 inch wide. I spoke with my contact at…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 9

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 10

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 11

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Are the Spring-loaded Barrels Part # TLS9000 Available Without the Chains

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching