Will the TorkLift SuperHitch Magnum Work with my Hellwig Big Wig Sway Bar?

Question

Question:

One more question is whether or not the Hellwig Big Wig sway bar I have installed on my 2013 Silverado will interfere with this hitch install. I dont think so but best to double check,

asked by: Bob

0

Expert Reply:

No. The TorkLift SuperHitch Magnum # TLC1208-30 will not be hindered by your Hellwig Big Wig sway bar; it's actually designed to be used with these types of aftermarket suspension enhancements, so you won't have any problems using both together.

expert reply by: Erik B

0

Answer 1

Thanks for the picture. The TorkLift StableLoad Rear Suspension Upgrade w Quick-Disconnects item #TLA7311 aren't going to be of any help to you because your overload spring is already engaged due to the weight in the bed of your Ram 3500. I am…

view full answer...

Answer 2

A certain amount of noise is normal with the Super Springs suspension stabilizers, especially on rough or uneven pavement. According to Super Springs, the bracket that attaches the Super Springs stabilizer to your truck's leaf springs has two…

view full answer...

Answer 3

Hey Taylor. The TorkLift SuperHitch Magnum item #TLD1111-30 will install in place of your factory hitch on your 2021 Ram 3500 long bed dually's factory hitch. However, the rear brackets of the TorkLift Tie Downs item #TL75FV you purchased, are…

view full answer...

Answer 4

We did have a customer come back and tell us that their TorkLift SuperHitch Magnum #TLD1102-30 did fit with their Hellwig sway bar but we don't have specific instructions for the sway bar or the hitch.

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

Thanks for writing in, Marco. The plug that Lance uses on their campers is a proprietary design, and unfortunately, there’s currently no aftermarket adapter available, at least not one that we carry. According to the Lance owner’s manual, the plug…

view full answer...

Answer 7

The 6-pole sockets that we carry can only handle up to 12 gauge wire so the only way to really swap away from Lance's proprietary connector would be to treat it like a standard camper and switch to a junction box and 7-way connector like parts…

view full answer...

Answer 8

Hey John. No, you will not have to remove your TorkLift SuperHitch item #TLD1111-30 or any tie downs to install the Hellwig Big Wig Rear Anti-Sway Bar item #HE24MR on your 2021 Ram 3500. Does your Ram 3500 have a diesel engine? The Hellwig Big Wig…

view full answer...

Answer 9

Yes, the Hellwig Big Wig Rear Anti-Sway Bar - 1-5/16" Diameter #HE24MR is confirmed to fit the 2023 Ram 3500 models with the 6.7L diesel engine. This will work with 2WD/4WD models and is fine with dually models as well.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Will the TorkLift SuperHitch Magnum Work with my Hellwig Big Wig Sway Bar?

Product Page this Question was Asked From

Continue Researching