What Size are the Mounting Holes on the Junior Locking Stainless Steel Flush Door Latch

Question

Question:

What size are the screw or rivet mounting holes on the latch

asked by: Eric S

0

Expert Reply:

I spoke with Redneck Trailer Supplies and they informed me that the mounting holes on the Junior Locking Stainless Steel Flush Door Latch part # L1883 are about 3/16" diameter.

expert reply by: Conner L

0

Answer 1

The "Junior" Non-Locking Steel Flush Door Latch #N1980 can be welded in place or you can drill the flange for installation with screws as you stated or rivets. If you want predrilled holes and a lock you can use the "Junior"…

view full answer...

Answer 2

To run a charge line to your battery you will first need to install a 7-Way on your trailer. This can be done using the Epicord 7-Way Molded Trailer Plug with Junction Box #277-000141. The Black wire in the junction box is the one that will carry the…

view full answer...

Answer 3

You can use a 7-Way and 4-Way connector at the same time just as long as you are not overloading the light circuits. If your camper has a lot of outside lights like running lights, and brake/stop/turn lights then the lights that perform the same…

view full answer...

Answer 4

You would not be able to charge your battery through the wiring on your 4-way trailer connector. Since your truck has a 7-way connector, you could maintain the power to the battery but not charge it. To begin, you would need to cut off your 4-way…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 7

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 8

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 11

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

What Size are the Mounting Holes on the Junior Locking Stainless Steel Flush Door Latch

Product Page this Question was Asked From

Continue Researching