Can I Use Both the 7-Way and 4-Way Connectors at the Same Time on a 2015 Chevrolet Silverado
Question:
Hello, I have a truck camper that I plug into my rear 7 way plug on the back of my 2015 silverado, but also want to tow a boat trailer that is four way. I cannot use both at once because the covers on the connector cannot both be open at the same time. Can you tell me if this can even be done Using both connectors at once to power both the camper and the trailer lights, and if there is an adapter or something I can buy that will maybe split the 7 way? Please help!!
asked by: Don A
Expert Reply:
You can use a 7-Way and 4-Way connector at the same time just as long as you are not overloading the light circuits. If your camper has a lot of outside lights like running lights, and brake/stop/turn lights then the lights that perform the same functions on your boat trailer might be a little dim or the fuses might blow on those circuits.
For a 7-Way and 4-Way connector that you can use at the same time I recommend using the Curt T-Connector Vehicle Wiring Harness for Factory Tow Package # C55774. This will allow you to use both connectors at the same time by connecting to the US car connector at the rear of your 2015 Chevrolet Silverado.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 7-Way and 4-Pole Flat Connectors
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- 7 Round - Blade
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 7-Way and 4-Pole Flat Connectors
- Shop: Base Plate for Tow Bar
- Shop: Vehicle Tow Bar Wiring
- Shop: Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets for Class A Motorhomes
- Shop: Hollywood Racks RV Rider Bike Rack for 2 Electric Bikes - 2" Hitches - Frame Mount
- Shop: Trailer Hitch
- Shop: Brophy Cable Camper Jack - 57" Max Lift Height - 1,000 lbs - Qty 1
- Shop: Brophy Cable Camper Jacks - 57" Max Lift Height - 1,000 lbs - Qty 2
- Shop: Brophy Cable Camper Jacks - 67" Max Lift Height - 3,000 lbs - Qty 2
- Search Results: base plate for tow bar
- Shop: Reese Multi-Plug Wiring Harness for Factory Tow Package - 7-Way and 4-Way Flat Trailer Connectors
- Video: Review of Progressive Dynamics RV Power Converter - Standard Charge - PD79RR
- Video: Review of Roadmaster Replacement Hardware Kit Sterling Tow Bar 555 556 - RM910003-32
- Shop: Brake Controller
- Q&A: Recommended E-Bike Bike Rack That Has A Ramp And Can Mount To The Seat Post
- Search Results: trailer lights
- Video: What to Know About the Hollywood Racks Safety LED Light Bar for Bike Racks
- Search Results: bike rack light bar
- Search Results: trailer brake controller
- Search Results: progressive dynamics rv power converter
- Video: Curt T-Connector Vehicle Wiring Harness Installation - 2014 Jeep Grand Cherokee
- Q&A: Ideas For Adding Lights To Hollywood Racks RV Rider HLY64FR w/ Cover Over Bikes
- Video: Review of etrailer Hitch Cargo Carrier - e98943-44LED
- Search Results: trailer hitch
- Video: The Low-Down on the Curt Auxiliary LED Indicator Lights
- Search Results: vehicle tow bar brake system
- Shop: Camper Tie-Downs
- Article: Brake Controller Installation: Starting from Scratch
- Video: Let’s Check Out the "Junior" Locking Stainless Steel Flush Door Latch with Inside Release
on Custom Fit Vehicle Wiring
Mike S.
7/4/2024
I wanted to post this in case anyone else runs into this issue. You can easily remove the covers (just pull the long pin holding the cover) to the combo 7-pin /4-pin connector on a Silverado to allow you to use both. Both connectors WILL work at the same time. On my 2014 Silverado, I wanted to add an extra set of trailer lights because the car I was towing was large and made it hard to see the trailer lights. I bought a $35 set of magnetic trailer lights from harbor freights and just plugged them into the open 4-pin connector.