Landing Gear Replacement Needed for 2010 K-Z Durango 1500 295BH

Published 10/04/2019

Products Featured in This Question

Landing Gear Set - 36-1/2" Lift - 8,000 lbs

(764)

$329.86

Replacement Switch for Stromberg Carlson Electric Landing Gear

(67)

$79.77

Replacement Crank Handle for etrailer and Ram 5th Wheel Landing Gear

(57)

$24.77

Question:

I need to replace the landing gear legs on a 2010 Durango 1500KZ 295bh. It looks like someone moved it with the legs down and bent the shaft of the legs where it comes out of the bottom of the camper right at that opening.

asked by: Patty S

Expert Reply:

To replace the landing gear on your 2010 K-Z Durango 1500 295BH you will first need to take some measurements of where your weld stops are located. They should measure 15-1/2" on the inside and 17-1/2" to the outside which is a very standard measurement. If this is the case then I highly recommend the Landing Gear Set # RVLG-8000 because it is a cost-effective solution that has a total lift of 36-1/2" and is rated for 8,000 lbs. To use this system manually you need the hand crank # RVLG-HDL but if you'd like to operate these with an electric motor you need part # M1230 with a switch like part # LG-145236.

Attached is a photo showing the weld stops for this landing gear as well as a review video that you can check out. If you have different weld stop locations let me know what those measure and I can help you find a different replacement.

expert reply by: Jon G