Torque Rating for Lug Nuts when Mounting Provider ST235/80R16 Radial Tire 16" Viking Aluminum Wheel

Question

Question:

What is the torque for 1/2 x 20 lug nuts on these wheels? 2018 Wolfpack 325 pack13 5th wheel

asked by: Shawn M

1

Helpful Expert Reply:

You'd want to tighten 1/2 lug nuts to 90-100 ft lbs when mounting the Provider ST235/80R16 Radial Tire w 16" Viking Aluminum Wheel # A16RG8BMMFL80 that you referenced.

I attached a review video for this wheel and tire for you to check out as well.

expert reply by: Jameson C

1

Answer 1

The Kenda Karrier ST235/80R16 Radial Tire with Wheel, #AM34903, does not have a torque rating. The lug nut torque rating is based on the size of the wheel stud on your trailer. If you are unsure about what size stud is on your trailer, then you…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Hello Vernon, Great question. I actually reached out to Coleman-Mach to make sure. Based on what they told me, if your Keystone Alpine 3220RL was equipped with the In-Command system and factory prepped for a third AC, the Coleman-Mach Mach-C Everest…

view full answer...

Torque Rating for Lug Nuts when Mounting Provider ST235/80R16 Radial Tire 16" Viking Aluminum Wheel

Featured Help Information

Miscellaneous Media

Continue Researching