How to Determine Which Hole Setting to Use When Installing SuperSprings # SSA16MXKT

Updated 09/11/2019 | Published 09/10/2019

Question:

These springs have three hole settings on each side. Is it ok to set each end on a different hole or should each end always be on the same hole position?

asked by: Jay

Helpful Expert Reply:

There are different situations where SuperSprings recommends using different bolt holes of the # SSA16MXKT to give you the optimum support and ride quality.

For greater support and ride height when your suspension is under a constant load or if you have an older vehicle with some spring fatigue, install the helper springs using the upper bolt holes.

To maintain the factory ride and reduce the effect on your ride height, install using the lower bolt holes.

To balance support, height, and ride comfort, install using the upper hole on one end and the lower hole on the other.

expert reply by: Jameson C