Can ShurFlo Water Pump 2088-404-144 be Replaced with HydroMax Pump P25201

Question

Question:

can I use p25201 pump to replace a shurflo pump 2088-404-144

asked by: Joe R

0

Expert Reply:

Yes, you can replace your ShurFlo pump 2088-404-144 with the HydroMax pump part # P25201 that you also referenced. This will have a higher psi rating at 55 than what you have now so you'd have improved water pressure. What you have now is 40 psi.

expert reply by: Jameson C

0

Answer 1

I suggest the HydroMax RV Fresh Water Pump, #P25201 as this works well as a direct replacement for most 3-gallon-per-minute (GPM), 12V pump. From information available to me, it appears your existing Shurflo 2088-403-144 pump features very similar…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 10

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 11

Hey Patrick, thanks for the measurement. The Travel Door Latch for GE Appliances RV Refrigerator item #GE98FR has mounting holes 1-3/16" on center. It's designed for the 9.8 Cu. Ft. GE Appliances RV Refrigerator with Top Freezer item #GE58FR…

view full answer...

Answer 12

Hey Bill! The Rebel is the heavier duty SumoSprings jounce springs and they have the higher weight rating at 3,000 lbs #SS64VR or 5,000 lbs #SS27GR. I usually only recommend these heavy duty versions if you have a lot of weight in the truck bed or on…

view full answer...

Can ShurFlo Water Pump 2088-404-144 be Replaced with HydroMax Pump P25201

Product Page this Question was Asked From

Continue Researching