Wire Gauge Of Optronics LED Combination Trailer Tail Lights TLL16RK

Question

Question:

can you tell what gauge wire is in this kit Thanks

asked by: Michael B

0

Expert Reply:

The wire gauge used in the LED Combination Trailer Tail Lights - Submersible part # TLL16RK is 20 gauge according to Optronics. This may seem light but the lights are LED and draw very little power. You can use Deka Heat Shrink Butt Connector - 22-18 Gauge - Nylon Insulation part # DW05743-10 to install the lights if you need them.

expert reply by: Heather A

0

Answer 1

The LED Reversible Trailer Fender Light with Chrome Trim part #MCL181ARCRB likely has 16-18 gauge wires so you'll use the Heat Shrink Butt Connector part #DW05744-5.

view full answer...

Answer 2

Super high-efficiency LED-type lights such as the Optronics #STL211RCB draw so little amperage (current) that you can wire them on your 20-foot trailer using 14-gauge (or heavier) wiring. We offer 10-gauge wire #10-1-1 by the foot. You will want to…

view full answer...

Answer 3

I reached out to my contact at Optronics and they were able to give me some additional information on this light set. The LED Combination Trailer Tail Lights #TLL16RK have full copper wires that are 18 gauge wires.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Wire Gauge Of Optronics LED Combination Trailer Tail Lights TLL16RK

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching