Is Lock Needed for Lower Hitch Opening of EcoHitch Stealth Hitch

Question

Question:

Can the hitch mount be locked to the vehicle?

asked by: Richard

0

Expert Reply:

While there isn't a locking pin for the lower portion of the EcoHitch Stealth Trailer Hitch Receiver # EH84GR the good news is this won't be a high-theft item at all for a few reasons. Most people would not assume that it comes off as it appears like a standard hitch, even if they knew it came off they'd have to have the correct size wrench on them to remove it, and even if knew it wouldn't really be of much value to anyone. This is a super specific application which the likelihood of someone needing this exact part would be very slim.

Let's say though that you had a nice bike rack and bikes in the hitch opening and you wanted a way to prevent people from stealing the hitch opening and the rack/bikes. What you could do is run a cable lock like part # e98891 through the bike frames and then to the safety chain loops on the main body of the hitch.

expert reply by: Jameson C

0

Answer 1

Hello David, Thanks for writing in! I am happy to help you get the right setup for carrying your bikes and towing your sailboat. It sounds like you are out there enjoying life the right way. It looks like you already found the hitch I would…

view full answer...

Answer 2

Hey Thomas, we have the Curt trailer wiring harness part #C56040 that is a fit for your 2026 Subaru Crosstrek Wilderness and would be what you'd need to start with for trailer wiring. This is a 4-way so to convert it to a 7-way and wire up a…

view full answer...

Answer 3

Hello Mike, thanks for reaching out. We do offer a few different hitches for the 2026 Subaru Crosstrek, the Curt #C22MJ, the Draw-Tite #76209 and the EcoHitch #EH57CR. All 3 of these hitches place the receiver in virtually the same position beneath…

view full answer...

Answer 4

Hey Chris. The Trailer Mate Trailer Hitch item #TMT94FR weighs 25 lbs. It has been confirmed to fit the 2025 Subaru Crosstrek. The bottom of the receiver sits 11-1/2" above the ground. It has a 1,500 lbs towing capacity and 150 lbs maximum…

view full answer...

Answer 5

Hey Mike, great question! The Stealth Hitches Hidden Rack Receiver #391TES317 doesn't have provisions for safety chains because it's designed to be used only for cargo applications like a bike rack or cargo carrier. If you're wanting the…

view full answer...

Answer 6

Yes. The EcoHitch Stealth Trailer Hitch Receiver #EH84GR has safety chain loops on the downward tube that the receiver will insert into. Since it sounds like you'll be towing, you will also need a wiring harness, ball mount and hitch ball. For…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Is Lock Needed for Lower Hitch Opening of EcoHitch Stealth Hitch

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching