How Far is Curt Hitch for 2019 Hyundai Ioniq Recessed Under Rear Bumper
Updated 05/31/2019 | Published 05/30/2019
Question:
What is the dimension from the mounting hole to the edge of the bumper for 24963 Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4inch ?
asked by: David
Expert Reply:
Sounds like you are trying to determine where the Curt hitch part # C11486 is going to sit when installed relative to the bumper of your vehicle. When we installed this hitch on a similar 2018 Hyundai Ioniq we found that from the center of the hitch pin hole out to the furthest point out on the rear bumper measures 5 inches. I also attached a picture that shows this dimension that I took from the install video for the hitch I also attached.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Key Recommendation for a Sears Sport 20-SV Carrier
- Article: Rust Prevention
- Q&A: How to Add 5-Way Wiring Connector to a 2024 Toyota Grand Highlander With Factory 4-Way Connector
- Q&A: What is the Difference Between Class 1 and Class 2 Hitches for the Scion XB
- Q&A: Trailer Hitch & Wiring Harness Fit For 2024 Mitsubishi Outlander
- Q&A: Recommended Hitch and Installation Prep for a 2018 Hyundai Ioniq
- Q&A: 2019 Hyundai Ioniq Plug-In Hybrid Wiring Kit Recommendation for Thule Bike Rack Tail Lights
- Q&A: Trailer Hitch Fit for 2019 Hyundai Ioniq Plug In Hybrid
- Article: Trailer Wiring Diagrams
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Parts Needed to Add Hydraulic Drum Brakes to a Trailer
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Which Sway Control Hitch is Right For Your Trailer?