Mounting Hole Spacing of Trailer License Plate Light with Housing # LP81BB

Question

Question:

Want to use on 2015 equipment trailet

asked by: Paul I

0

Expert Reply:

The mounting hole spacing of the Trailer License Plate Light with Housing # LP81BB that you referenced is 3-7/16 inches.

I attached a review video for this for you to check out as well.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Hey Dusty, your 16 inch trailer wheels definitely have the PSI rating for a Load Range G tire in your size of 235/85-16 like the part #LHWL410 that we offer. In almost all situations the limiting factor will be the valve stem and not the wheel and it…

view full answer...

Answer 2

Yes you can go with a 10 Ply Load Range E tire for your trailer in the size of 225/75-15. For that we have the part #TR225LRE which has a weight capacity of 2,830-lb max load at 80 psi. What I also really like about this tire is that it has a higher…

view full answer...

Answer 3

I attached a picture for you to use as a guide for wiring in your trailer's 4-way wiring to a 7-way socket connector. The yellow wire is the left turn/stop circuit that you have out of the connector.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Mounting Hole Spacing of Trailer License Plate Light with Housing # LP81BB

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching