Replacement Surge Brake Actuator Recommendation for 1997 Eagle Spirit Boat Trailer
Updated 05/16/2019 | Published 05/15/2019 >
Products Featured in This Question
Question:
Dear Sir, I have a 1997 Eagle Spirit tandem axle boat trailer. It carries a very heavy Fiberglass 23’ 6” Cuddy Cabin Cruiser Monterey Montura 236. The old Demco Model BA-66 actuator and coupler needs replaced. The #s are rusted pretty bad and it’s possible it could also be a DA-66 but it looks like a BA-66 to me. I have included collage picture showing coupler, actuator wheels axle etc. The coupler stamped #’s say its rated at 6000lbs. Label for trailer is no longer legible but I have the vin from the title. I measured the axle diameter and it looks to be 3 inches. Wheels are 5-lug. I have surge drum brakes on the aft axle. It looks like I need the coupler/actuator and brake drums/kit and a brake line kit from actuator to drum brakes. Do you have what I need for complete replacement of coupler/actuator and brakes/brake lines for both back wheels?
asked by: Dennie S
Helpful Expert Reply:
Thanks for the picture of your trailer. From that I can tell that the replacement actuator # 099-175-00 is what you'd need.
Three inch diameter axles are typically 5,200 lb but the highest rated hub/drum we have with a 5 on 4-1/2 inch bolt pattern like you have is 3,500 like the part # AKHD-545-35-EZ-K. If your drum measures 10 inch in diameter then this is the correct replacement most likely but it would still be a good idea to get the bearing numbers out of your hub so that we can verify the correct fit and then from there also pick out assemblies. The hub mentioned has bearing numbers L68149 and L44649.
I attached a help article that will walk you through the entire process of adding brakes to a trailer that will help you pick out the components needed as well.
Product Page this Question was Asked From
Dexter DX7.5 Drop-N-Go Brake Actuator - Drum Brakes - 2" Ball - Zinc Plated - 7,500 lbs
- Brake Actuator
- Surge Brake Actuator
- Farm Trailer
- Boat Trailer
- Construction Trailer
- Travel Trailer
- Utility Trailer
- Bolt-On
- 7500 lbs GTW
- 2 Inch Ball Coupler
- 3 Inch Channel Tongue
- Drum Brakes
- No Lockout
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Suspension Enhancement
- Shop: SumoSprings Solo Custom Helper Springs - Rear Axle
- Shop: Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Search Results: marine bearing grease lubricants sealants adhesives
- Shop: Dexter DX7.5 Drop-N-Go Brake Actuator - Drum Brakes - 2" Ball - Zinc Plated - 7,500 lbs
- Search Results: grease
- Shop: LubriMatic LMX Industrial Strength Grease - 14 oz. Cartridge
- Video: Dexter DX7.5L A-60 Brake Actuator Spec Review
- Video: Review of the Replacement Shock Absorber Spring Kit for Dexter Brake Actuators
- Shop: Replacement Damper for Model 20 Actuator - Qty 1
- Shop: Replacement Master Cylinder Assembly for Dexter Model 60 and Aero 7500 Brake Actuators - Drum
- Q&A: Measurements for Dexter DX7.5L A-60 Brake Actuator
- Q&A: Comparing The Dexter T43397007K And T63FR Brake Actuators
- Video: The Low-Down on the Replacement Damper for Model 20 Actuator
- Shop: Replacement Shock Absorber for Dexter Model 60 Brake Actuators
- Q&A: Which Dexter Surge Brake Actuator Replaces The Atwood 85778 For Drum Brakes?
- Q&A: Where Do the Rubber Bearings Go On the Titan/Dico Model 10 Surge Brake Actuator
- Q&A: Available Replacement Parts for Tie Down Engineering LP7000 Actuator
- Q&A: Master Cylinder Replacement Kit Needed for Dexter DX7.5 Drum Actuator # 099-175-00
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Search Results: trailer tires and wheels
- Shop: Brake Controller
- Search Results: trailer jack



